• Ingresar
2 Year Warranty

PCI-1285-AE DSP-based 8-axis Stepping and Servo Motor Control Universal PCI Card

  • Encoder input is 10 MHz for 4xAB mode, 2.5 MHz for CW/CCW mode
  • Pulse output up to 5 Mpps
  • Memory buffer (10K points) for trajectory planning which is designed in DSP
  • Supports E-Gear, and helical interpolation
  • Supports E-CAM providing 256 points to describe the CAM profiles which buffers located in DSP
  • Hardware emergency input
  • Watchdog timer
  • Position latch
  • Position compare triggering up to 100 KHz, and memory buffer is up to 100 K points in DSP
  • Programmable interrupt
  • Supports gantry mode by semi-closed loop pulse train control
  • RDY/LTC-dedicated input channels & SVON/CMP/CAM-DO/ERC-dedicated output channels are switchable for general input and output purposes

(Impuestos NO incluidos)
Agregar al Carrito Comprar

Accesorios

PCI-1285-AE

IoTMainProduct:PCI-1285-AE

DSP-based 8-axis Stepping and Servo Motor Control Universal PCI Card

Accesorios

  • Mini-SCSI-100 Shielded Cable, 3m

    US$290.00

{{relatedTitle}}

IoTMainProduct + {{numOfSelectedRelatedProducts}}Accesorios

Subtotal {{subTotalStr}}

Especificaciones Detalladas

General

  • Humidity (Storage) 5~95% RH (non-condensing)
  • Humidity (Operating) 5~95% RH (non-condensing)
  • Connectors 2 x 100-pin mini-SCSI female connector

Counter/Encoder Input

  • Counting Range 32-bit

Encoder Type and Interface

  • Input Type Quadrature (A/B phase) or up/down
  • Input Range 0~1 VDC for low; 3.5~5 VDC for high
  • Max. Input Frequency 10 MHz under x4 A/B phase mode
  • Counts per Enc. Cycle x1, x2, x4 (A/B phase only)

Pulse Type Motion Control

  • Motor Driver Support Pulse-type servo/stepping
  • Interpolation 2 to 8-axis linear, 2-axis circular, X-Y plane with Z thread helical interpolation
  • Max. Output Speed 5 Mbps
  • Step Count Range ±2, 147, 483, 646
  • Pulse Output Type Pulse/direction (1-pulse, 1-direction type) or CW/CCW (2-pulse type)
  • Velocity Profiles T-Curve, S-Curve

Frequency

  • Signal Input Logic level 1: 10~30 VDC Logic level 0: 0~3 VDC

Local I/O

  • General Input Signal Input voltage: 24 VDC Max. Input delay: 100 us Max. (isolation delay) Signal: EMG (emergency stop) ORG, LMT+, LMT- INPOS (in position signal) LTC (counter latch) RDY (servo ready) ALARM (servo alarm)
  • General Output Signal Output voltage: Open collect 24 VDC Max Output delay: 100 us Max. (isolation delay) Sink current: 100 mA per channel Signal: CMP (position compare in range output) SVON (servo on) RALM (reset driver alarm) ERC (counter clear signal)