• Ingresar
2 Year Warranty

PCI-1245L-AE 4-axis Stepping and Servo Motor Control Universal PCI Card

  • Encoder input is 4 MHz for 4xAB mode, 1 MHz for CW/CCW mode
  • Pulse output up to 1 Mpps and the output type can be switched to differential or single-end by jumper setting
  • Supports 2 axis linear interpolation
  • Supports T/S-curve
  • Supports speed override
  • Hardware emergency input
  • Watchdog timer
  • Supports programmable acceleration/deceleration rate
  • Programmable interrupt
  • RDY dedicated input channels & SVON/ERC dedicated output channels are switchable for general input and output purposes
Certifications CE CE CE

(Impuestos NO incluidos)
Agregar al Carrito Comprar

Accesorios

PCI-1245L-AE

IoTMainProduct:PCI-1245L-AE

4-axis Stepping and Servo Motor Control Universal PCI Card

Accesorios

  • PCI-1240 Wiring Terminal, DIN-rail Mount

    US$95.00
  • 2-Axis 50-pin SCSI DIN-rail motion wirin

    US$105.00
  • SCSI-100 Shielded Cable, 3m

    US$240.00
  • SCSI-100 to 2*SCSI-50 Shielded Cable, 1m

    US$85.00
  • SCSI-100 to 2*SCSI-50 Shielded Cable, 2m

    US$105.00

{{relatedTitle}}

IoTMainProduct + {{numOfSelectedRelatedProducts}}Accesorios

Subtotal {{subTotalStr}}

Especificaciones Detalladas

General

  • Humidity (Storage) 5~95% RH (non-condensing)
  • Humidity (Operating) 5~95% RH (non-condensing)
  • Connectors 1 x 100-pin SCSI female connector

Counter/Encoder Input

  • Counting Range 32-bit

Encoder Type and Interface

  • Input Type Quadrature (A/B phase) or up/down
  • Input Range 0~1 VDC for low; 3.5~5 VDC for high
  • Max. Input Frequency 4 MHz under x4 A/B phase mode
  • Counts per Enc. Cycle x1, x2, x4 (A/B phase only)

Pulse Type Motion Control

  • Motor Driver Support Pulse-type servo/stepping
  • Interpolation 2-axis linear interpolation
  • Max. Output Speed 1 Mbps
  • Step Count Range ±2, 147, 483, 646
  • Pulse Output Type Pulse/direction (1-pulse, 1-direction type) or CW/CCW (2-pulse type)
  • Velocity Profiles T-Curve, S-Curve

Frequency

  • Signal Input Logic level 1: 10~30 VDC Logic level 0: 0~3 VDC

Local I/O

  • General Input Signal Input voltage: 24 VDC Max. Input delay: 100 us Max. (isolation delay) Signal: EMG (emergency stop) ORG, LMT+, LMT- INPOS (in position signal) LTC (counter latch) RDY (servo ready) ALARM (servo alarm)
  • General Output Signal Output voltage: Open collect 24 VDC Max Output delay: 100 us Max. (isolation delay) Sink current: 100 mA per channel Signal: CMP (position compare in range output) SVON (servo on) RALM (reset driver alarm) ERC (counter clear signal)